 | | Parts Tracker - Using L3P-check to scan submitted files —Steve Bliss
|
| | | Hey y'all- I'm just sort of starting to get to adding L3P-check'ing to the Parts Tracker submit function. I took a look at the documented messages, and tried to sort them out according to whether or not any particular error was cause to reject a (...) (23 years ago, 17-Oct-01, to lugnet.cad.dev.org.ldraw)
|
| | | |
| | | | | Re: Parts Tracker - Using L3P-check to scan submitted files —Paul Easter
|
| | | | | (...) Looks good. (...) I have used the phrase "0 end of subpart", "0 end of file", etc in some of the parts I have made. Will these get rejected? I usually always try to keep them lowercase. (...) I'm not sure about this one. I feel that new parts (...) (23 years ago, 18-Oct-01, to lugnet.cad.dev.org.ldraw)
|
| | | | | |
| | | | | | | Re: Parts Tracker - Using L3P-check to scan submitted files —Steve Bliss
|
| | | | | | (...) [snip] (...) [snip] (...) No, they should be fine. If you use a line like 0 END ROTATE (upper- or lower-case), that would cause the error message. Maybe we should have specified (back in the day, too late now) that meta-commands all have to (...) (23 years ago, 19-Oct-01, to lugnet.cad.dev.org.ldraw)
|
| | | | | | |
| | | | | Re: Parts Tracker - Using L3P-check to scan submitted files —Jacob Sparre Andersen
|
| | | | | Steve: (...) [...] Seems okay. (...) [...] Seems okay. (...) I would say yes. The last two definitely should, since they indicate unneeded resource use. The first one should really be split in to two triangles, if it really is intended to be (...) (23 years ago, 18-Oct-01, to lugnet.cad.dev.org.ldraw)
|
| | | | | |
| | | | | | | Re: Parts Tracker - Using L3P-check to scan submitted files —Steve Bliss
|
| | | | | | (...) [snip areas of agreement] (...) Which is sloppy, but not a killer error. (...) I didn't list the non-coplanar message with the "reject" group is because the thresholds of coplanarity are variable, not fixed. So we need to agree on what level (...) (23 years ago, 18-Oct-01, to lugnet.cad.dev.org.ldraw)
|
| | | | | | |
| | | | | | | | Re: Parts Tracker - Using L3P-check to scan submitted files —Jacob Sparre Andersen
|
| | | | | | Steve: (...) I assume that L3P reports the relevant lines, so it is trivial to remove one of the offending ones. (...) Right. Set a reasonably large threshold (0.1?) and reject based on it. Jacob (23 years ago, 18-Oct-01, to lugnet.cad.dev.org.ldraw)
|
| | | | | | |
| | | | | Re: Parts Tracker - Using L3P-check to scan submitted files —Steve Bliss
|
| | | | I finally formatted the material about L3P messages vs. part files and put it under the reference area of the Parts Tracker. (URL) If you don't have L3P installed on your computer, you can check your part files at: (URL) This script must upload your (...) (23 years ago, 8-Feb-02, to lugnet.cad.dev.org.ldraw)
|
| | | | |
