Subject:
|
Re: modeling monorail ramps (TrackDraw)
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Thu, 21 Aug 2003 14:46:59 GMT
|
Viewed:
|
1275 times
|
| |
| |
In lugnet.cad.dev, Cary Clark wrote:
> Track Designer models a pair of monorail upper and lower ramp parts as a single
> piece. Do you view this as a feature or a restriction?
>
> I can't recall seeing half of a ramp unconnected to the other half in a layout.
> Have you found a need for half a ramp? Short of using a hacksaw, have you
> figured how to connect anything other than the mate to the mid-elevation end of
> a ramp piece?
>
> Thanks for the feedback
> Cary
one possible reason to have it seperate is that you could use the piece for
esthetic reasons. You could simulate an entry down or up, and stop at that
section. Having a stop-go right before makes this single ramp segment functional
(so actually not purely for looks), as it is needed to contain the first car.
Thus, I'd like to have the ability to only use 1 piece of the ramp. However,
this is not a very big must-have.
Paul
|
|
Message has 1 Reply: | | Re: modeling monorail ramps (TrackDraw)
|
| (...) ... (...) ... Here's what I came up with: The monorail parts file separately models the up and down ramps. So layouts containing up/down ramps have two part references, one for each half. The toolbar file contains a button that adds both (...) (21 years ago, 21-Aug-03, to lugnet.cad.dev)
|
Message is in Reply To:
| | modeling monorail ramps (TrackDraw)
|
| Track Designer models a pair of monorail upper and lower ramp parts as a single piece. Do you view this as a feature or a restriction? I can't recall seeing half of a ramp unconnected to the other half in a layout. Have you found a need for half a (...) (21 years ago, 21-Aug-03, to lugnet.cad.dev, lugnet.trains)
|
11 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|