Subject:
|
Re: Unnoficial Parts (Tiles with Edge)
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Fri, 26 Jul 2002 18:00:49 GMT
|
Viewed:
|
496 times
|
| |
|
|
In lugnet.cad, Steve Bliss writes:
> In lugnet.cad, Jeff Boen wrote:
>
> >
> > > I believe that the 1x1, 1x2 and 2x2 tiles exist without the groove, but have
> > > never come across other sizes in this state.
> >
> > I agree. I actually have some 1x2's without the groove (especially ones with a
> > "grille" top) but have never seen the longer 1x without a groove. I figure for
> > the ones that came in both flavors we keep the current files and give the
> > grooved version an appended name (i.e. XXXXXa.dat). For those that we think
> > only came with the groove, the updated versions take on the XXXX.dat filename.
>
> I'm doing some checking, to try and make sure we've got the right numbers,
> and that we know which parts came in the older flavor.
How's this coming along? Partsref still lists Tile 1 x 4 (without groove); was
this piece discovered to exist?
It would also be nice if the grooveless parts could have "a" appended to their
numbers, and "without Groove" appended to their names (as is the case with the
grille tile).
(Yes, I looked in the Tracker, but I didn't see these changes.)
TWS Garrison
|
|
Message has 1 Reply:
 | | Re: Unnoficial Parts (Tiles with Edge)
|
| (...) have (...) a (...) for (...) filename. (...) was (...) I am not aware of this part existing without the grooves, so I think the introduction of 2431b was a mistake. I think ....a and ....b numbers should only be used where two versions of the (...) (22 years ago, 28-Jul-02, to lugnet.cad.dev)
|
Message is in Reply To:
8 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
