Subject:
|
Re: Unnoficial Parts (Tiles with Edge)
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Fri, 7 Feb 2003 16:36:40 GMT
|
Viewed:
|
655 times
|
| |
|
|
In lugnet.cad.dev, Chris Dee writes:
> In lugnet.cad.dev, Thomas Garrison writes:
<stuff about grooved/grooveless Tile 1 x 4>
> > It would also be nice if the grooveless parts could have "a" appended to
> > their numbers, and "without Groove" appended to their names (as is the case
> > with the grille tile).
> I am not aware of this part existing without the grooves, so I think the
> introduction of 2431b was a mistake. I think ....a and ....b numbers should
> only be used where two versions of the same part do exist
Where "part" relates to geometry, ignoring pattern.
<snip stuff that was done to fix Tile 1 x 4...but 2431b is still on the
official list?>
> Comments ?
It would still be nice to have 3070, 3069, and 3068 moved to 3070a, 3069a, and
3068a, respectively. . .that's been done with every other part variation (where
varients have been LDrawn) and might help cut down the widespread confusion
over these parts, which have not been produced for over 25 years
(unfortunately).
TWS Garrison
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Unnoficial Parts (Tiles with Edge)
|
| (...) have (...) a (...) for (...) filename. (...) was (...) I am not aware of this part existing without the grooves, so I think the introduction of 2431b was a mistake. I think ....a and ....b numbers should only be used where two versions of the (...) (22 years ago, 28-Jul-02, to lugnet.cad.dev)
|
8 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
