Subject:
|
Re: Type 5 lines at the edge of primitives
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Sun, 5 May 2002 23:39:23 GMT
|
Viewed:
|
588 times
|
| |
|
|
In lugnet.cad.dev, Ross Crawford writes:
> I'm not sure if I understand this properly - if the second "test" point is
> down the line where the cylinder joint (between two rects) would be if it
> was attached to a cylinder, won't that work? It'll mean the same line may
> occasionally be displayed twice, but generally it'd be displayed by one or
> the other hemisphere - if one misses it, the other would get it, wouldn't it?
>
> Or am I totally missing the problem?
Well, I did as you suggested, and it solved the problem without introducing
any new ones. I was also able to then visualize why it worked on a
continuing sphere once I had it working.
--Travis Cobbs (tcobbs@REMOVE.halibut.com)
|
|
Message has 1 Reply:
 | | Re: Type 5 lines at the edge of primitives
|
| (...) Cool! Glad I could help! And after looking at the discussion Don linked to, I'm wondering if a similar thing could be done for type 5s on cylinder edges - make the second test point on the plane where a rectangle would be if it was butted up (...) (23 years ago, 6-May-02, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: Type 5 lines at the edge of primitives
|
| (...) I'm not sure if I understand this properly - if the second "test" point is down the line where the cylinder joint (between two rects) would be if it was attached to a cylinder, won't that work? It'll mean the same line may occasionally be (...) (23 years ago, 5-May-02, to lugnet.cad.dev)
|
12 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
