 | | LDLite 1.7 suggestions
|
|
hey gyug... recently we spoke about implementing F5 refresh into LDLite... here are a few other ideas that have popped up over the last few days while authoring parts... since we probably all have come up from our roots in LEdit... i often find (...) (26 years ago, 15-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: Ldlite suggestions
|
|
(...) you may not be aware... but you can go to Options|Options in LDLite (1.6) and set the X and Y offset to move your model in LDLite render space... -X values will move the model to the left, +X to the right... -Y values move the model up and +Y (...) (26 years ago, 15-Mar-99, to lugnet.cad.dev)
|
| |
| | SW colors & parts
|
|
What is the best color # to use for tan and also the orange which are in the SW sets. Also the 3x3 plate corner used on the front of the landspeeder, is this a new piece or has it just not been made yet, I can't find it? Also John vZ if you are (...) (26 years ago, 15-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: L3PAO Suggestion
|
|
Also pass along the idea the have special options for default backgrounds ,such as snow, grass, and space. onyx wrote in message ... (...) keep (...) suggestion (...) itself... (...) one (...) (26 years ago, 14-Mar-99, to lugnet.cad.dev)
|
| |
| | (canceled)
|
|
|
| |
| | Ldlite suggestions
|
|
After doing a lot of virtual building over the past few days I noticed that sometimes in Ldlite a part of the model would be cut off down in the blh corner even though there was plenty of room in the urh corner area. For the next version would it be (...) (26 years ago, 14-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: MPD format
|
|
That is all there is to it. "0 FILE name.dat" starts a subfile. The subfile ends when end-of-file or another "0 FILE name.dat" line is reached. By convention, tools like L3P and LDLite, when given an mpd file, will render the first subfile. The (...) (26 years ago, 14-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: Technic (Throwbot) Leg with Ball Joints
|
|
I've avoided using Throwbot/Slizer in the name, using just "Technic Leg with Ball Joints 3 x 7 x 1" The piece is stamped with "32173" -gyug ps. "Slizer" is better sounding than "Throwbot". (...) (26 years ago, 14-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
(...) agreed again... my point being that TLG *may* use different element numbers to differentiate between certain parts in different colors (perhaps not 1x2 bricks) but that our concern should only be separate part numbers when the physical makeup (...) (26 years ago, 14-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
(...) ^^^...^^^ Agreed, except that in the case of the 1x2 brick -- there are two molds still in use today: one with a post down the center and one without. The one without the post is of course the one used for little windows -- like in (...) (26 years ago, 14-Mar-99, to lugnet.cad.dev)
|
