Subject:
|
Re: I'm doing the revolving/"secret" door parts
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Sat, 11 Nov 2000 14:38:14 GMT
|
Viewed:
|
807 times
|
| |
|
|
In lugnet.cad.dev, Steve Bliss writes:
> In lugnet.cad.dev, Franklin W. Cain wrote:
>
> > 30102.dat (30344.dat?),
> > "Panel 2 x 8 x 6 Revolving Door"
> >
> > 30102p01.dat,
> > "Panel 2 x 8 x 6 Revolving Door - Ninja pattern"
> >
> > The "door" piece as two different numbers stamped on it.
> > Which one do I use? (I listed both of them above.)
>
> Yuck. That's bad. For those of you at home, Franklin is absolutely right.
> If you look on the bottom of the door part, there are two part numbers,
> right next to each other (but far enough apart, and with a different
> type-style, that it's obvious they aren't actually one big number).
> There's no way this could be a situation of two molded parts which are
> welded/glued together later.
>
> Maybe the 30102 was rebranded, when the Ninja print was put on it. Weren't
> these pieces new with Ninja? The numbering seems to indicate they were
> designed at the same time as the Wild West pieces.
>
> For now, go with 30102, and I'll check my sources...
>
> Steve
The only other occurance of this type that I am aware of is the bucket lids.
Some of these have two moulded on numbers, which are clearly part numbers. I've
been advised in the past that this was because the large LEGO / DUPLO logos are
moulded onto the large studs at a later stage - and the two numbers refer to
the LEGO version and the DUPLO version.
Could there be something similar here?
Chris
|
|
Message has 1 Reply:
 | | Re: I'm doing the revolving/"secret" door parts
|
| (...) I'm not sure. Other than the printing, I don't know of any other post-mold processing that would be done on this part. One of the numbers on the Ninja door panel looked suspiciously like it had been imprinted on the door at some time after the (...) (24 years ago, 13-Nov-00, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: I'm doing the revolving/"secret" door parts
|
| (...) How about: 30101.DAT Door 2 x 8 x 6 Frame Revolving 30102.DAT Door 2 x 8 x 6 Revolving 30102P01.DAT Door 2 x 8 x 6 Revolving with Ninja Pattern I'm not keen on using themes in part names, but in this case, I can't think of a better name. (...) (...) (24 years ago, 9-Nov-00, to lugnet.cad.dev)
|
8 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
