Subject:
|
I'm doing the revolving/"secret" door parts
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Thu, 9 Nov 2000 06:20:17 GMT
|
Viewed:
|
668 times
|
| |
|
|
I'm calling "dibs" on the following:
30101.dat,
"Panel 2 x 8 x 6 Revolving Frame"
30102.dat (30344.dat?),
"Panel 2 x 8 x 6 Revolving Door"
30102p01.dat,
"Panel 2 x 8 x 6 Revolving Door - Ninja pattern"
These were the best names I could think of.
I'm listing the "door" piece with the _FRAME_'s dimensions,
even though the door is actually smaller than this,
'cuz the door piece isn't usable just by itself
and must be inserted into the frame piece.
Steve,
The "door" piece as two different numbers stamped on it.
Which one do I use? (I listed both of them above.)
Tore,
Whenever you want to list these on your parts tracker,
please show them as "In Progress".
Thanks,
Franklin
=====
Franklin Cain (and please do *not* call me "Frank" ;-)
fwcain@yahoo.com | http://fcain.tripod.com/
------------------------------------------------------------
USE OR DISTRIBUTION OF MY EMAIL ADDRESS FOR UNSOLICITED
COMMERCIAL PURPOSES (I.E., SPAM) IS STRICTLY PROHIBITED.
|
|
Message has 2 Replies:
 | | Re: I'm doing the revolving/"secret" door parts
|
| (...) How about: 30101.DAT Door 2 x 8 x 6 Frame Revolving 30102.DAT Door 2 x 8 x 6 Revolving 30102P01.DAT Door 2 x 8 x 6 Revolving with Ninja Pattern I'm not keen on using themes in part names, but in this case, I can't think of a better name. (...) (...) (24 years ago, 9-Nov-00, to lugnet.cad.dev)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
