Subject:
|
Re: I'm doing the revolving/"secret" door parts
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Thu, 9 Nov 2000 12:10:41 GMT
|
Viewed:
|
594 times
|
| |
|
|
> The "door" piece as two different numbers stamped on it.
> Which one do I use? (I listed both of them above.)
I recomend using 30102 because both 30101.dat, the frame and the door
would have been created at the same time so it would fit that they would
use part numbers that are next to each other.
|
|
Message is in Reply To:
 | | I'm doing the revolving/"secret" door parts
|
| I'm calling "dibs" on the following: 30101.dat, "Panel 2 x 8 x 6 Revolving Frame" 30102.dat (30344.dat?), "Panel 2 x 8 x 6 Revolving Door" 30102p01.dat, "Panel 2 x 8 x 6 Revolving Door - Ninja pattern" These were the best names I could think of. I'm (...) (24 years ago, 9-Nov-00, to lugnet.cad.dev)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
