| | Re: DAT voting page up Jonathan Wilson
|
| | (...) i have fixed that and send the fix to terry. also i added a missing stud at the edge next to the ramp. (...) i will fix this asap (...) i will not fix those (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| | |
| | | | Re: DAT voting page up Todd Lehman
|
| | | | (...) Without the actual element in front of you, how can you be 100% sure that you've actually fixed the problem? (...) Have you asked yourself why you missed this in the first place? --Todd (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: DAT voting page up Jonathan Wilson
|
| | | | | | (...) i have fixed it because i built kings mountain fortress on the part and all the studs are in place (...) it was a small oversight on my part. even if i had the part in front of me then i still could have missed the stud (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| | | | | | |
| | | | | | Re: DAT voting page up Roy Earls
|
| | | | | Todd Lehman wrote in message ... (...) You can't. Even with a part in hand you can't because how do you know every part thru the ages is the same. A case in point, I just did an inventory of all the parts I have and found two 45 1 x 2 slopes that (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| | | | | |
| | | | Re: DAT voting page up Bram Lambrecht
|
| | | | (...) The curved edges are an essential part of the piece, especially when viewed in LDLite or POV-Ray. Not modeling them would be like leaving the curved edges off of the Windscreens - the edges are a highly recogizable feature of the part. --Bram (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: DAT voting page up Jonathan Wilson
|
| | | | (...) the canyon raised baseplate does not have the rounded edges. (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: DAT voting page up Todd Lehman
|
| | | | (...) Then it's broken too. :) --Todd (26 years ago, 27-Feb-99, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: DAT voting page up Steve Bliss
|
| | | | (...) True, but it's also a precedent. I'd rather have the bottom surface than curved edges. I'd consider a part with all surfaces more accurate than a part with closely-modeled upper surfaces, but the underside completely missing. Maybe I'm just (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| | | | |