Subject:
|
Re: Centering (was: I need help with the new tread links)
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Fri, 26 Nov 1999 15:51:58 GMT
|
Viewed:
|
573 times
|
| |
|
|
"Dave Schuler" <orrex@excite.com> writes:
> That works fine for me, because for now I use LEdit almost
> exclusively. I'm a little familiar with the "/T C" function;
> does this set the "center" to the center of the piece? How
> about when using subassemblies while drafting larger
> models--does "/ T C" set the "center" to the center of the whole
> assembly?
> I'm not trying to be obtuse, really! I've just had the sense that
> I'm missing a fundamental property of LEdit.
/ T C sets the center of rotation to the position of the blinking cursor
and leaves it there until you change the center of rotation again. When
you start the program, the center is at 0,0,0
--Bram
Bram Lambrecht / o o \ BramL@juno.com
-------------------oooo-----(_)-----oooo-------------------
WWW: http://www.chuh.org/Students/Bram-Lambrecht/
-----------------------------------------------------------
|
|
Message is in Reply To:
13 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
