Subject:
|
Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Tue, 13 Apr 1999 20:24:25 GMT
|
Viewed:
|
792 times
|
| |
|
|
In lugnet.cad.dev, Jonathan Wilson writes:
> with the pin long with stop bush: none of the other technic pins fit into a
> beam either... i think it is something wrong with the positioning of the
> primitives
Do you mean they're of-center in the hole? If so, change the movement rate
from "Normal" to "Fine" (by pressing "m", I believe). Then the piece will move
1 LDU, and you can center it in the hole.
Jeff
|
|
Message is in Reply To:
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
