Subject:
|
Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Mon, 12 Apr 1999 07:00:00 GMT
|
Viewed:
|
934 times
|
| |
|
|
On Sun, 11 Apr 1999 01:41:08 GMT, Bram Lambrecht <braml@juno.com> wrote:
> jonathon wilson writes:
> > with the pin long with stop bush: none of the other technic pins fit
> > into a beam either... i think it is something wrong with the positioning • of
> > the primitives
>
> Huh? the pins fit just fine. However, you left a ring around the middle
> of your part which would never allow a technic beam to pass over it. (As
> insticking the pin through two technic beams at once)
> --Bram
Jonathan, whether you understand what the complaints are about or not, just
take it on faith that this part is _wrong_.
As someone else said, if you would get this piece and actually look at it, you
would clearly see the flaws.
Right now, people trying to describe the errors to you is about as constructive
as the blind men describing the elephant.
-- Terry K --
|
|
Message is in Reply To:
7 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
