CAD Development : 1129


CAD / Development / 1129	1128 \| 1130

Subject:	Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
Newsgroups:	lugnet.cad.dev
Date:	Sat, 10 Apr 1999 23:34:50 GMT
Viewed:	866 times

with the pin long with stop bush: none of the other technic pins fit into a beam either... i think it is something wrong with the positioning of the primitives

Message has 2 Replies:

		Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
(...) of (...) Huh? the pins fit just fine. However, you left a ring around the middle of your part which would never allow a technic beam to pass over it. (As insticking the pin through two technic beams at once) --Bram Bram Lambrecht / o o \ (...) (26 years ago, 11-Apr-99, to lugnet.cad.dev)

		Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
(...) Do you mean they're of-center in the hole? If so, change the movement rate from "Normal" to "Fine" (by pressing "m", I believe). Then the piece will move 1 LDU, and you can center it in the hole. Jeff (26 years ago, 13-Apr-99, to lugnet.cad.dev)

Message is in Reply To:

		Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
[followups set to lugnet.cad.dev] (...) Whoa. Wow. Yes. That is frightening. I don't have any more of these 3L Friction-Peg/Stop-Bush combo elements left (sold them all) to compare to Jonathan's drawing, but I do remember, now that you point it (...) (26 years ago, 10-Apr-99, to lugnet.cad, lugnet.cad.dev)

7 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search