CAD Development : 1138


CAD / Development / 1138	1137 \| 1139

Subject:	Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
Newsgroups:	lugnet.cad.dev
Date:	Sun, 11 Apr 1999 01:41:08 GMT
Viewed:	859 times

jonathon wilson writes: > with the pin long with stop bush: none of the other technic pins fit > into a beam either... i think it is something wrong with the positioning • of > the primitives Huh? the pins fit just fine. However, you left a ring around the middle of your part which would never allow a technic beam to pass over it. (As insticking the pin through two technic beams at once) --Bram Bram Lambrecht / o o \ BramL@juno.com -------------------oooo-----(_)-----oooo------------------- WWW: http://www.chuh.org/Students/Bram-Lambrecht/ -----------------------------------------------------------

Message has 1 Reply:

		Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
(...) Jonathan, whether you understand what the complaints are about or not, just take it on faith that this part is _wrong_. As someone else said, if you would get this piece and actually look at it, you would clearly see the flaws. Right now, (...) (26 years ago, 12-Apr-99, to lugnet.cad.dev)

Message is in Reply To:

		Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
with the pin long with stop bush: none of the other technic pins fit into a beam either... i think it is something wrong with the positioning of the primitives (26 years ago, 10-Apr-99, to lugnet.cad.dev)

7 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search