| |
In lugnet.cad, Travis Cobbs wrote:
| |
In lugnet.cad, Jim DeVona wrote:
| |
Here’s a quick example: sitting in a LEGO cockpit looking out at your
wingman.
|
It’s worth noting that if you get the POV-Ray camera info from LDView and
render in POV-Ray, you should get exactly the same view there (assuming you
use the same aspect ratio).
|
I was thinking of that. I tried it briefly the other night but I must have had a
different aspect ratio, because the rendering appeared far outside the ship. I’m
getting up to speed on POV-Ray, though, so I’ll definitely try it again.
| |
| |
Travis, since I already had the LDView code set up I reduced the
strafeAmount and motionAmount values used in
ModelWindow::processKeyDown to 0.05. This made it much easier to make
fine adjustments to the camera position; even smaller values may be useful.
Perhaps it would be worth adding a Preferences setting to control these
values?
|
The sensitivity is pretty messed up. It doesn’t properly track the frame
rate, so if you have a high frame rate it goes too fast, and if you have a
low frame rate, it goes too slow. I think the proper solution would be for
me to fix that.
|
Ah, I see. Sounds good. Yes, initially the camera would jump across or out of
the cockpit at the slightest touch. I changed the value so I could nudge it
around easier within that area.
Jim
|
|
Message has 1 Reply:
Message is in Reply To:
13 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
