 | | Re: Modeling without the real element -- bad
|
|
(...) I'm not sure how a rule like that could be strictly enforced, but you could certainly put down a foot and declare from here on out that modeling pieces blindly is verboten because they (a) cannot possibly be 100% correct except in extremely (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) Without the actual element in front of you, how can you be 100% sure that you've actually fixed the problem? (...) Have you asked yourself why you missed this in the first place? --Todd (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) i have fixed that and send the fix to terry. also i added a missing stud at the edge next to the ramp. (...) i will fix this asap (...) i will not fix those (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) i have fixed that and send the fix to terry. (...) i will fix this asap (...) i will not fix those (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
well... my raised baseplate is that accurate and is finished. (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
Sproaticus wrote in message ... (...) My vote would be to use the part number that people can see with out takeing apart the boat, i.e. the 30086 number. The 30087 number is only of value if you take the boat apart. Somthing I feel very few people (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) need (...) You should measure with a ruler or with lego parts (or for detailed parts people have resorted to calipers). With a plate and a brick, you can make pretty accurate measurements based on wall thickness (4 ldu), plate thickness (8 (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
Terry K wrote in message <36d5fd53.5480877@lu...et.com>... (...) seemingly (...) number (...) both (...) I thought you had to break the two halves apart to get at the 30087 number. Do you have to break it apart? If so can you use them afterward? If (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
jonathan wilson wrote in message ... (...) go (...) need (...) Its precise enough for me. Since we already know that LDraw itself is not accurate, but it is precise. Roy (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
jonathan wilson wrote in message ... (...) done (...) You know, I've never looked at the bottom since you usually can't do anything with the bottom of a baseplate. Matter of fact I don't think I've ever looked at any of the real ones I have other (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
