Subject:
|
Re: new part - 71014 Castle Greatsword
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 23 Mar 2000 17:16:06 GMT
|
Viewed:
|
5394 times
|
| |
|
|
Typo fixed... :-(
In lugnet.cad.dat.parts, Franklin W. Cain writes:
> In lugnet.cad.dat.parts, John VanZwieten writes:
> >
> > I've got several suggestions for you on this part:
> >
> > Only type 2 and type 5 lines should have color 24.
> > Edge primitives should take color 16,
> > since the color 24 is hard-coded into the primitive definition.
>
> Yeah, I noticed this also (*after* I posted it, of course). :-P
> I've already fixed this in the version I've got here,
> and I'll re-post it later (I wanted to wait and see if
> there were any other fixes it needed,
> and speaking of which... ;-)
>
> > I think the more narrow edgelines for the grip are offset
> > so that they are placed in the middle of the wider sections of the grip.
>
> I don't understand this.
> The way I see the grip of this piece in reality
> is that there are a bunch of toruses ("tori"?...been too many years
^^^^^
(I'm a clumsy typist......)
> since I took Latin ;-) stacked atop one another,
> but the only way I could simulate this was with cone/rings.
> The "edge lines" in this case are to simulate the gaps
> that I see between the toruses when I look at the greatsword
> real close.
>
> > You should use type 2 and/or type 5 lines
> > for the thick areas of the blade.
> > If you view the sword from the front in wireframe mode,
> > the thickness of the blade dissappears.
>
> ACK!
> Good one.
> I'll have to fix this.
>
> > Edgelines should be added where the guard intersects the quillioins,
> > and where the grip intersects the pommel.
>
> [shudder]
>
> I'm not really that comfortable
> with intersecting curved surfaces
> (as amply demonstrated by the way
> I klooged together the Cattlehorns piece. ;-)
>
> I honestly did the best I could
> with my current understanding
> of the curved primitives.
>
> If anyone has some really, *really* specific advice
> ("insert the following pre-coded line...."),
> I'd be happy to accept it.
>
> > If any of this is unclear, just let me know :)
>
> Thanks! :-)
>
> Franklin
|
|
Message is in Reply To:
 | | Re: new part - 71014 Castle Greatsword
|
| (...) Yeah, I noticed this also (*after* I posted it, of course). :-P I've already fixed this in the version I've got here, and I'll re-post it later (I wanted to wait and see if there were any other fixes it needed, and speaking of which... ;-) (...) (27 years ago, 23-Mar-00, to lugnet.cad.dat.parts)
|
14 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
