| |
I downloaded copies of LDraw and MLcad a few days ago, and I’ve been building
digital versions of a few of my models, but I ran into a couple of problems:
1. Using MLcad, I couldn’t get this
piece to close flush to this piece.
There was either a little gap at the top (just enough to be annoying), or a huge
gap at the bottom (enough to really stand out). I haven’t tried out any of the
other interfaces, but I juggled the numbers by hand a bit, and I was able to
come up with a clean match after about 4 tries. If anyone is interested in
borrowing the numbers, here’s the DAT file:
0 ROTATION CENTER 0 0 0 1 “Custom”
0 ROTATION CONFIG 0 0
1 0 -39 -48 -4 0 0 1 0 1 0 -1 0 0 30200.DAT
1 57 -76 -121 -5 0 0.686637 -0.727 0 0.727 0.686637 1 0 0 2418B.DAT
0
2. While I was building my latest model, I discovered that part
#2463 has portions inside the lower
corners that aren’t shading with the rest of the part. I noticed this because
when I attached it to a different colored part, I could see the studs through
the gaps on the outside of the base, but I couldn’t on the model (yes, I checked
to make sure the studs were lined up correctly). If you look at this from
either outside angle, you can see that the portions of the yellow studs that are
sticking up inside of the part are still visible, but there’s a thin black line
intersecting them, which is where the interior panel isn’t shading with the rest
of it. Is that intentional?
0 ROTATION CENTER 0 0 0 1 “Custom”
0 ROTATION CONFIG 0 0
1 0 4.477 -131.572 -9 1 0 0 0 1 0 0 0 1 2463.DAT
1 14 -35.522 -106 1.477 1 0 0 0 1 0 0 0 1 3005.DAT
1 14 4.478 -106 -38.523 1 0 0 0 1 0 0 0 1 3005.DAT
0
3. And finally, this is a long shot, but I’ve got to ask anyways...does anyone
have any plans to make a DAT file for the Ninja wrap?
If you’re only replying to part of this, please FUT only to the appropriate
groups.
|
|
Message has 2 Replies:
 | | Re: Cockpits, and Facets, and Ninja, oh my!
|
| (...) For some unknown reason, part 2463 is pretty much an empty shell with no bottom at all. It has edge lines on the bottom out in empty space, but no surfaces. It appears that this file hasn't been touched since 1999. It's not currently on the (...) (20 years ago, 25-Jul-04, to lugnet.cad.dat.parts, FTX)
|
15 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
