To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.dat.partsOpen lugnet.cad.dat.parts in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / LDraw Files / Parts / 5349
5348  |  5350
Subject: 
Re: Cockpits, and Facets, and Ninja, oh my!
Newsgroups: 
lugnet.cad.dat.parts
Date: 
Sun, 25 Jul 2004 00:21:23 GMT
Viewed: 
3926 times
  
In lugnet.cad, David Laswell wrote:
   2. While I was building my latest model, I discovered that part #2463 has portions inside the lower corners that aren’t shading with the rest of the part. I noticed this because when I attached it to a different colored part, I could see the studs through the gaps on the outside of the base, but I couldn’t on the model (yes, I checked to make sure the studs were lined up correctly). If you look at this from either outside angle, you can see that the portions of the yellow studs that are sticking up inside of the part are still visible, but there’s a thin black line intersecting them, which is where the interior panel isn’t shading with the rest of it. Is that intentional?

For some unknown reason, part 2463 is pretty much an empty shell with no bottom at all. It has edge lines on the bottom out in empty space, but no surfaces. It appears that this file hasn’t been touched since 1999. It’s not currently on the part tracker, either.

--Travis Cobbs



Message has 2 Replies:
  Re: Cockpits, and Facets, and Ninja, oh my!
 
(...) Hmm, I guess nobody cares about it but me. :) I recently found out that it was officially discontinued as a LEGO brick (as compared to just not having been used for a while), which was a bit disappointing, since at the time I needed eight (...) (20 years ago, 25-Jul-04, to lugnet.cad.dat.parts, FTX)
  Re: Cockpits, and Facets, and Ninja, oh my!
 
(...) OK, I'm revising this part - basically the whole underside needs re-working. Even the outlines that are there are not correct. Watch this space. Chris (20 years ago, 25-Jul-04, to lugnet.cad.dat.parts, FTX)

Message is in Reply To:
  Cockpits, and Facets, and Ninja, oh my!
 
I downloaded copies of LDraw and MLcad a few days ago, and I've been building digital versions of a few of my models, but I ran into a couple of problems: 1. Using MLcad, I couldn't get (URL) this piece> to close flush to (URL) this piece>. There (...) (20 years ago, 24-Jul-04, to lugnet.cad, lugnet.cad.mlcad, lugnet.cad.dat.ideas, lugnet.cad.dat.parts, FTX)

15 Messages in This Thread:




Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR