Subject:
|
Re: Cockpits, and Facets, and Ninja, oh my!
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sun, 25 Jul 2004 15:49:40 GMT
|
Viewed:
|
4043 times
|
| |
|
|
In lugnet.cad.dat.parts, Travis Cobbs wrote:
| |
In lugnet.cad, David Laswell wrote:
| |
2. While I was building my latest model, I discovered that part
#2463 has portions inside the lower
corners that aren’t shading with the rest of the part. I noticed this
because when I attached it to a different colored part, I could see the
studs through the gaps on the outside of the base, but I couldn’t on the
model (yes, I checked to make sure the studs were lined up correctly). If
you look at this from either outside angle, you can see that the portions of
the yellow studs that are sticking up inside of the part are still visible,
but there’s a thin black line intersecting them, which is where the interior
panel isn’t shading with the rest of it. Is that intentional?
|
For some unknown reason, part 2463 is pretty much an empty shell with no
bottom at all. It has edge lines on the bottom out in empty space, but no
surfaces. It appears that this file hasn’t been touched since 1999. It’s not
currently on the part tracker, either.
--Travis Cobbs
|
OK, I’m revising this part - basically the whole underside needs re-working.
Even the outlines that are there are not correct.
Watch this space.
Chris
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Cockpits, and Facets, and Ninja, oh my!
|
| (...) For some unknown reason, part 2463 is pretty much an empty shell with no bottom at all. It has edge lines on the bottom out in empty space, but no surfaces. It appears that this file hasn't been touched since 1999. It's not currently on the (...) (20 years ago, 25-Jul-04, to lugnet.cad.dat.parts, FTX)
|
15 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
