Subject:
|
Re: Problems with new part and S\3069BS01.DAT
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Mon, 6 Jan 2003 03:14:13 GMT
|
Viewed:
|
5112 times
|
| |
|
|
Wanting to confirm one other thing. Is it intentional that a .ldr file with
the same name as a part will not actually be procssed and result in a .pov
file with only the part? In this case, I was constructing set 4532 and found
a pov file with just a picture of a cabinet (part 4532) :)
Thanks,
Karl
In lugnet.cad.dat.parts, Lars C. Hassing writes:
> In lugnet.cad.dat.parts, Orion Pobursky writes:
> > In lugnet.cad.dat.parts, Karl Asha writes:
> > > In my problem description I didn't mention that I had actually included the
> > > part in an mlcad model, so effectively it was created as a Type 1 line. The
> > > solution to the problem though seems to have been removing the part from the
> > > ldraw models directory and moving it into the parts directory. Is it correct
> > > to assume that l3p will not shrink full 'models' that it finds in that
> > > directory, or something similar?
> >
> >
> > Hmmm... Lars will have to give conformation of this but I think L3P was
> > handling your part as a submodel. That would explain why the tile subpart
> > was shrunk when it was in any other directory but the parts directory
>
> Confirmed! Well spotted.
>
|
|
Message is in Reply To:
 | | Re: Problems with new part and S\3069BS01.DAT
|
| (...) Confirmed! Well spotted. Any non-scaling reference to a part is shrunk, except if the reference is from a part. A part is currently defined as a file located in PARTS. "s\3069bs01.dat" (as a path) is located in PARTS. When the new part was in (...) (24 years ago, 3-Jan-03, to lugnet.cad.dat.parts)
|
9 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
