Subject:
|
Re: Problems with new part and S\3069BS01.DAT
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 2 Jan 2003 21:58:23 GMT
|
Viewed:
|
4661 times
|
| |
|
|
In lugnet.cad.dat.parts, Karl Asha writes:
> In my problem description I didn't mention that I had actually included the
> part in an mlcad model, so effectively it was created as a Type 1 line. The
> solution to the problem though seems to have been removing the part from the
> ldraw models directory and moving it into the parts directory. Is it correct
> to assume that l3p will not shrink full 'models' that it finds in that
> directory, or something similar?
Hmmm... Lars will have to give conformation of this but I think L3P was
handling your part as a submodel. That would explain why the tile subpart
was shrunk when it was in any other directory but the parts directory
-Orion
|
|
Message has 1 Reply:
 | | Re: Problems with new part and S\3069BS01.DAT
|
| (...) Confirmed! Well spotted. Any non-scaling reference to a part is shrunk, except if the reference is from a part. A part is currently defined as a file located in PARTS. "s\3069bs01.dat" (as a path) is located in PARTS. When the new part was in (...) (24 years ago, 3-Jan-03, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: Problems with new part and S\3069BS01.DAT
|
| In my problem description I didn't mention that I had actually included the part in an mlcad model, so effectively it was created as a Type 1 line. The solution to the problem though seems to have been removing the part from the ldraw models (...) (24 years ago, 2-Jan-03, to lugnet.cad.dat.parts)
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
