Subject:
|
Re: Problems with new part and S\3069BS01.DAT
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 2 Jan 2003 20:26:19 GMT
|
Viewed:
|
4384 times
|
| |
|
|
In lugnet.cad.dat.parts, Karl Asha writes:
> While trying to create the 1x2 tile with keyboard pattern piece, I ran into
> a problem that I have broken down into a simple example:
>
> 0 Tile 1 x 2 test
> 1 16 0 0 0 1 0 0 0 1 0 0 0 1 s\3069bs01.dat
> 4 16 20 0 10 -20 0 10 -20 0 -10 20 0 -10
>
> Can someone explain why the edges of the part face seem to extend out on
> each side beyond the subpart when run through l3p and then rendered with povray?
>
> An example rendering of the problem is available at
> http://www.blackdown.org/~karl/lego/test.PNG
>
> Thanks for any assistance.
>
> Karl
Do you have the seam option turned on?
This option causes the parts to be scaled a little smaller
to generate the seams between parts.
For rendering single parts, turn the seam option off.
Niels
|
|
Message is in Reply To:
 | | Problems with new part and S\3069BS01.DAT [DAT]
|
| While trying to create the 1x2 tile with keyboard pattern piece, I ran into a problem that I have broken down into a simple example: 0 Tile 1 x 2 test 1 16 0 0 0 1 0 0 0 1 0 0 0 1 s\3069bs01.dat 4 16 20 0 10 -20 0 10 -20 0 -10 20 0 -10 Can someone (...) (24 years ago, 2-Jan-03, to lugnet.cad.dat.parts)
|
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
