Subject:
|
Re: Problems with new part and S\3069BS01.DAT
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 2 Jan 2003 20:11:34 GMT
|
Viewed:
|
1194 times
|
| |
|
|
I appear to have answered my own question, though I don't understand the
answer :) It seems that if the part is located in the LDRAW\MODELS
directory, the extended face problem exists. If the part is moved into
LDRAW\PARTS, however, the problem disappears. Perhaps this is some subtlety
in the way that the models directory is handled?
Karl
In lugnet.cad.dat.parts, Karl Asha writes:
> While trying to create the 1x2 tile with keyboard pattern piece, I ran into
> a problem that I have broken down into a simple example:
>
> 0 Tile 1 x 2 test
> 1 16 0 0 0 1 0 0 0 1 0 0 0 1 s\3069bs01.dat
> 4 16 20 0 10 -20 0 10 -20 0 -10 20 0 -10
>
> Can someone explain why the edges of the part face seem to extend out on
> each side beyond the subpart when run through l3p and then rendered with povray?
>
> An example rendering of the problem is available at
> http://www.blackdown.org/~karl/lego/test.PNG
|
|
Message is in Reply To:
 | | Problems with new part and S\3069BS01.DAT [DAT]
|
| While trying to create the 1x2 tile with keyboard pattern piece, I ran into a problem that I have broken down into a simple example: 0 Tile 1 x 2 test 1 16 0 0 0 1 0 0 0 1 0 0 0 1 s\3069bs01.dat 4 16 20 0 10 -20 0 10 -20 0 -10 20 0 -10 Can someone (...) (22 years ago, 2-Jan-03, to lugnet.cad.dat.parts)
|
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
