| |
In lugnet.cad.dat.parts, Steve Bliss writes:
> Actually, by the guidelines for parts I posted, the flex-axle subparts
> should be in the parts directory.
>
> Moving the hose segments to parts/s/ would prevent the shrinkage
> problem, but I think there are better solutions.
No, moving the hose segments to parts/s/ would NOT prevent the
shrinkage problem.
It doesn't matter whether a part is located in PARTS or PARTS/S,
it is still considered as a part.
Whenever a (sub-)part is referenced from another part, it is not shrunk further.
Only the model-to-part reference is shrunk.
Think e.g. of 3935.DAT "Wing 4 x 4 Right" which simply references
3936.DAT "Wing 4 x 4 Left"
Therefore IMHO the solution is to put all pieces of a curved hose into
a new part (or an MPD subfile).
Then the complete hose will be shrunk as a whole when referenced from
the model, just like the other parts referenced from the model.
/Lars
|
|
Message has 1 Reply:
Message is in Reply To:
11 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
