Subject:
|
Re: x191 & x192 part in the Parts tracker
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 4 Jan 2002 22:03:02 GMT
|
Viewed:
|
1453 times
|
| |
|
|
In lugnet.cad.dat.parts, Steve Bliss writes:
> In lugnet.cad.dat.parts, ludo soete wrote:
>
> > B.T.W. We have now 2 parts in the parts tracker, the X191 & X192. This means
> > that one part can be eliminated when i do this changes, isn't it?
>
> But you'll need two parts -- one for the top of the connector, and one
> for the bottom. And a third for the two put together...
>
> Steve
Hi Steve,
A question for the top & bottom part:
Must the top & bottom part be 100 percent accurate?
I mean the sides that aren't visible when using it as an assembled piece?
I have alreddy 2 parts, but they need some more work if they need to be 100
percent accurate (see a picture from those parts at:
http://www.geocities.com/ludo_soete/ldraw_parts.htm
IF people would like to use this part i think they will all use the
assembled piece (shortcut)
The 2 separate parts have the following numbers on it:
top part = lego number 2912
bottom part = lego number 2913
BTW: The top part concist of 2 pieces, the gray top part and a red piece (no
number on it) with holds the wire and both pieces are screwed together with
a small black screw.
Regards,
Ludo
|
|
Message has 1 Reply:
 | | Re: x191 & x192 part in the Parts tracker
|
| (...) No, they don't have to be completely accurate. More accuracy is better, though. (...) Right. (...) Right, exactly. Nearly 100% of the usage will be the shortcut file. But LEGO identifies the top and bottom as two separate items, so we should (...) (23 years ago, 7-Jan-02, to lugnet.cad.dat.parts)
|
Message is in Reply To:
6 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
