Subject:
|
x191 & x192 part in the Parts tracker
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sat, 29 Dec 2001 21:47:37 GMT
|
Viewed:
|
1449 times
|
| |
|
|
Hi,
I looked to the parts tracker review for my posted parts x191 & x192. There
seems to be an overlay error, and the reviewer * Deckard * thinks that i
should remove the electric wire. I can do this verry easily, so this means
also that both pieces (x191 & x192) become the same piece, thus also
positive for the library (only one part instead of two). The difference
between both pieces is the lenght of the electric wire.
Now, if i remove the electric wire, then you'll can look through the piece
where the electric wire runs through.
You can get an idee abouth the part if you take a look at my home page at
following link :
http://www.geocities.com/ludo_soete/ldraw_parts.htm
The part x191 & x192 are a shortcut from the ** 9v Track power connector TOP
part ** and the ** 9v Track power connector BOTTOM part **
I know, i need to update my home page, but i get sometimes problems with
Geocities, such as runtime errors or too much visitors/passed time unit
according to there rules for a free home page. .
Regards,
Ludo
Now my questions are:
1) Should i remove the electric wire?
2) Should i create a electric wire subpart?
3) If question 2 is positive, how long should this wire be?
If nesesarry for a better preview, i can post my DAT files here.
|
|
Message has 1 Reply:
 | | Re: x191 & x192 part in the Parts tracker
|
| Hello Ludo, (...) There (...) I am/Was the reviewer. It is a very nice part. IMHO the wire should be removed and made a subpart of it. This subpart should be very very short so that you can use a tool like the Emacs Bendable thingie Creater to model (...) (23 years ago, 29-Dec-01, to lugnet.cad.dat.parts)
|
6 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
