Subject:
|
Re: x475.dat, "Minifig Hat Tri-Corner"
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 5 Jan 2001 16:46:29 GMT
|
Viewed:
|
981 times
|
| |
|
|
In lugnet.cad.dat.parts, Hakan Tandogan wrote:
> "Franklin W. Cain" <fwcain@yahoo.com> writes:
>
> > 0 (Author's Note:
> > 0 If you want to use one of the feather-plumes with this part,
> > 0 I strongly suggest that you create a sub-file
> > 0 containing a reference (type-"1" line) to this DAT file
> > 0 and the another reference to the feather-plume,
> > 0 aligning the feather-plume at the appropriate 120-degree angle,
> > 0 and then including a reference to this sub-file
> > 0 within your main file, aligning this sub-file
> > 0 at the corresponding, opposite 120-degree angle.
> > 0 Note that the "peghole" is at the co-ordinate (0,-10,-12),
> > 0 and your reference to the feather-plume should be
> > 0 at this same co-ordinate.
> > 0 --FWC ;-)
>
> Could you provide an additional "comple shortcut"? I
> think it would make working with your part easier for other
> people.
Or, at least, replace the paragraph of comments with something like:
0 To put a feather on the hat, use the following line:
0 1 15 0 -10 -12 1 0 0 0 1 0 0 0 1 XXXXa.dat
The suggestions about using subfiles are accurate, but it's not appropriate
to put them in part files.
Steve
|
|
Message has 1 Reply:
 | | Re: x475.dat, "Minifig Hat Tri-Corner" [DAT]
|
| (...) OK, Steve, how about this? If this is OK, LMK, and I'll email you this updated version. ;-) Thanks, Franklin 0 Minifig Hat Tri-Corner 0 Name: x475.dat 0 Author: Franklin W. Cain <fwcain@yahoo.com> 0 Unofficial Element 0 0 CATEGORY Minifig (...) (24 years ago, 5-Jan-01, to lugnet.cad.dat.parts)
|
Message is in Reply To:
10 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
