 | | Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush —Bram Lambrecht
|
| | | (...) I hate to break it to you Jonathon, but neither of these parts are correct. The computer screen pattern is not the same one as on the other computer screen parts. The way you made the tecnic pin, it would be useless because you could never get (...) (26 years ago, 10-Apr-99, to lugnet.cad)
|
| | | |
| | | | | Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush —Todd Lehman
|
| | | | [followups set to lugnet.cad.dev] (...) Whoa. Wow. Yes. That is frightening. I don't have any more of these 3L Friction-Peg/Stop-Bush combo elements left (sold them all) to compare to Jonathan's drawing, but I do remember, now that you point it (...) (26 years ago, 10-Apr-99, to lugnet.cad, lugnet.cad.dev)
|
| | | | |
| | | | | | Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush —Laurentino Martins
|
| | | | | (...) I have centered some of my mockup parts by creating a model that inludes only that part. Then using LDAO, I inline the model and the dummy model becomes the part itself, but this time is centered! :-) Laurentino Martins (...) (26 years ago, 10-Apr-99, to lugnet.cad.dev)
|
| | | | | |
| | | | | | Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush —Jonathan Wilson
|
| | | | with the pin long with stop bush: none of the other technic pins fit into a beam either... i think it is something wrong with the positioning of the primitives (26 years ago, 10-Apr-99, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush —Bram Lambrecht
|
| | | | | (...) of (...) Huh? the pins fit just fine. However, you left a ring around the middle of your part which would never allow a technic beam to pass over it. (As insticking the pin through two technic beams at once) --Bram Bram Lambrecht / o o \ (...) (26 years ago, 11-Apr-99, to lugnet.cad.dev)
|
| | | | | |
| | | | | | | Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush —Terry Keller
|
| | | | | | (...) Jonathan, whether you understand what the complaints are about or not, just take it on faith that this part is _wrong_. As someone else said, if you would get this piece and actually look at it, you would clearly see the flaws. Right now, (...) (26 years ago, 12-Apr-99, to lugnet.cad.dev)
|
| | | | | | |
| | | | | | Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush —Jeff Stembel
|
| | | | (...) Do you mean they're of-center in the hole? If so, change the movement rate from "Normal" to "Fine" (by pressing "m", I believe). Then the piece will move 1 LDU, and you can center it in the hole. Jeff (26 years ago, 13-Apr-99, to lugnet.cad.dev)
|
| | | | |
