Subject:
|
Re: Callout a single part
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 15 Jun 2005 13:15:13 GMT
|
Viewed:
|
786 times
|
| |
|
|
In lugnet.cad, Jaco van der Molen wrote:
> Would it be possible to create a callout for a single part instead of a
> submodel?
>
> This would be useful for decorated parts that are positioned in the model so
> that you cannot see the pattern.
> Or parts that are partially "hidden" or that you want to point out specifically.
> http://www.hccamsterdam.nl/brick/scans/04000/4482/053.jpg (step 12)
> http://www.hccamsterdam.nl/brick/scans/04000/4482/052.jpg (step 9)
>
> You could do this now with single parts by creating a submodel with the one part
> in it, use that submodel as a part and call that out.
And this works. I use it often.
>
> I am still looking for a way to do step 8 and 11 in the same example as above.
Why are step 8 and 11 unachievable in the current model of LPub using sub-models
for callouts? Why do you want a different way to to what you can already do?
>
> You can do this by creating a submodel, but then you'll end up with 2 steps
> (like in step 10)
Can you please explain, in hypothetical LPub meta commands that you want to
express your solution in?
LPub generates images when it hits a STEP metacommand, or the implied STEP at
end of a file (if parts were added after the last real STEP). I don't see how
you can express the callout in step 10 without a STEP.
>
> Jaco
Kevin
|
|
Message has 1 Reply:
 | | Re: Callout a single part [DAT]
|
| (...) I agree that it does, but I think it is a bit too circuitous. I suppose this is too difficult to implement in LPub For now then making a submodel for each callout with only one part and no step in it, doing it like this makes me (once again) (...) (19 years ago, 15-Jun-05, to lugnet.cad)
|
Message is in Reply To:
| | Callout a single part
|
| Would it be possible to create a callout for a single part instead of a submodel? This would be useful for decorated parts that are positioned in the model so that you cannot see the pattern. Or parts that are partially "hidden" or that you want to (...) (19 years ago, 15-Jun-05, to lugnet.cad)
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
