Subject:
|
Re: Callout a single part
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 15 Jun 2005 18:57:42 GMT
|
Viewed:
|
1455 times
|
| |
|
|
> By placing LPUB SUBMODEL_STEP BEGIN IGN prior to the 0 STEP command in a
> submodel, this will be ignored until the next LPUB SUBMODEL_STEP END meta
> command.
Sorry, I meant:
By placing LPUB SUBMODEL_STEP BEGIN IGN prior to the 0 STEP command in a
submodel, the following steps will be ignored until the next LPUB
SUBMODEL_STEP END meta command and not show in the callout.
|
|
Message is in Reply To:
 | | Re: Callout a single part [DAT]
|
| (...) I agree that it does, but I think it is a bit too circuitous. I suppose this is too difficult to implement in LPub For now then making a submodel for each callout with only one part and no step in it, doing it like this makes me (once again) (...) (20 years ago, 15-Jun-05, to lugnet.cad)
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
