Subject:
|
Re: Reinstalling all cad stuff
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 12 Mar 1999 03:56:09 GMT
|
Viewed:
|
1949 times
|
| |
|
|
OK. I'm having the same problem described below in #1. Every thing works
for files on my drive, but when I click on the "Open this as an LDraw .Dat
file" on the Lugnet.Cad.Dat pages, I get a blank screen. One thing I notice
is that just before LDLite says "Finished in xxxx.seconds" (or something to
that effect) I see "Syntax Error ??????" flash into that same area. It says
something else after the Syntax Error, but I have no idea what because it
goes by so fast.
But, if I put the LDLite 1.5 exe back, everything just works. Just the 1.6
exe seems to fail for me. I do have the LDDRAWDIR environment variable set.
And I am using the most up to date LDLite that I know of.
Any clues what stupid thing I'm doing wrong?
Kim
John Bauman wrote in message ...
> Same here.
> Steve Bliss wrote in message <36e529d2.4430308@lugnet.com>...
> > I've got the same problem, with LDLite 1.6.
> >
> > Steve
> >
> > On Tue, 9 Mar 1999 08:07:32 GMT, Paul Gyugyi <paul@gyugyi.com> wrote:
> >
> > > Are you using the brand-new, just-released yesterday LDLite 1.6?
> > > Your problem sounds like what happened in 1.5 if you did not have
> > > the LDRAWDIR environment variable set correctly.
> > > -gyug
> > >
> > > John VanZwieten wrote:
> > > >
> > > > Two problems so far:
> > > >
> > > > 1. I've got LDLite working with files off my hard drive, but it won't • work
> > > > for files on lugnet.cad.dat. It just loads LDLite and says "finished"
> > > > without drawing anything on the screen. If I save the file to hard • disk and
> > > > then open it, it draws fine, just not directly from lugnet.cad.dat.
> > > >
> > > > 2. LDAO problem (2.0.2): when I select options-tool manager, I get a
> > > > "Runtime error '339'
> > > > Component 'CCRPBD.OCX' or one of its dependencies not correctly • registered:
> > > > a file is missing or invalid."
> > > > then LDAO crashes.
> > > >
> > > > -John Van
>
>
>
|
|
Message has 1 Reply:
 | | Re: Reinstalling all cad stuff
|
| First, try the obvious: run 1.6 and reset the LDRAW base directory. I don't know exactly why, but that has helped before. Netscape+LDLite works OK for me, so I'm just guessing at the problem. After the "Finished" appears, go to the File/Save As menu (...) (26 years ago, 13-Mar-99, to lugnet.cad)
|
Message is in Reply To:
14 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
