Subject:
|
Re: Using stickers on LDraw models
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 6 Jun 2005 23:14:27 GMT
|
Viewed:
|
1186 times
|
| |
|
|
In lugnet.cad, Lars C. Hassing wrote:
> The only way to have the part and the sticker rendered correctly
> is to group them, so they can be shrunk together.
Well, I just tried Niels's L-386 on top of two 2x2 tiles,
all three parts put into a subfile.
However, this construction failed to generate a seam between the two tiles.
The subfile trick only works (or works best) if the sticker is applied
to only one part which is the same size or bigger than the sticker.
I have fixed L3P so it will not make the sticker disappear.
Until the release you must manually edit the POV file
replacing "1-SW/0.25" with "1" in the sticker seam matrix.
/Lars
|
|
Message has 1 Reply:
 | | Re: Using stickers on LDraw models
|
| (...) The L-386 can be attached to one 2x8 brick on the tail of the helicopter, but following the instructions the sticker is attached halfway both 2x8 bricks. What happens in your test, when you add one tile and the sticker into a subfile and leave (...) (19 years ago, 7-Jun-05, to lugnet.cad)
|
Message is in Reply To:
| | Re: Using stickers on LDraw models
|
| (...) Yes, this is clearly a bug. I've never used stickers, gotta try it. (...) I don't think the problem can be solved automatically. Well, avoiding the sticker disappearing can. But simply not applying seams or only applying seams in any dimension (...) (19 years ago, 6-Jun-05, to lugnet.cad)
|
10 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
