 | | Re: Overlapping polygons etc —Ross Crawford
|
| | | Thanks for your replies! (...) OK. I just thought with 24 studs being affected, the large increase in polygons may be a bad idea, but it's better to get it right. (...) AFAIK this part is only available in black, but better safe than sorry. (...) (...) (21 years ago, 5-Aug-03, to lugnet.cad)
|
| | | |
| | | | | Re: Overlapping polygons etc —Paul Easter
|
| | | | | (...) I think I missed what you meant earlier. I would not inline the stud for that, Unless it was a major piece of the part. which this is not. (...) Ok, I see it now. My laptop screen was not showing me enough detail. See my example below. I used (...) (21 years ago, 6-Aug-03, to lugnet.cad)
|
| | | | | |
| | | | | | | Re: Overlapping polygons etc —Ross Crawford
|
| | | | | | | (...) OK, I'm happy to do that. (...) Thanks for the suggestion! But I have another question, which I alluded to originally, but forgot about: What about the horizontal planes going down either side, and slicing through the studs, where they join (...) (21 years ago, 6-Aug-03, to lugnet.cad)
|
| | | | | | | |
| | | | | | | Re: Overlapping polygons etc —Ross Crawford
|
| | | | | | (...) OK, using your example as a guide, I finished off the part. First cut is at (URL) did notice, though, that using LDview, there is a definite line where the studs join the cylinders. I tried rotating the studs by 22.5 degrees to match, but the (...) (21 years ago, 6-Aug-03, to lugnet.cad)
|
| | | | | | |
| | | | | | | | Re: Overlapping polygons etc —Steve Bliss
|
| | | | | | (...) Leave the studs at 0 rotation. I didn't see the lines you mention. Steve (21 years ago, 12-Aug-03, to lugnet.cad)
|
| | | | | | |
| | | | | Re: Overlapping polygons etc —Orion Pobursky
|
| | | | (...) The wonderful thing about virtual bricks is that all parts are available in transparent colors -Orion (21 years ago, 6-Aug-03, to lugnet.cad)
|
| | | | |
