| | Re: I want to become a reviewer
|
|
(...) So I understand that studlogos may face any direction as long as they are not mirrored? How about a mix of rotated studlogos on one single part instead of all studslogos facing the same direction? E.g. some studlogos readable when the part is (...) (20 years ago, 4-Nov-04, to lugnet.cad, FTX)
|
|
| | Re: cylinders missing conditional lines?
|
|
(...) I checked a few official parts that use the 2-4cyli primitive. And all the parts I have checked so far are missing the conditional line at one end of the cylinder. So I suspect that part authors expect that all partial cylinder primitives have (...) (20 years ago, 4-Nov-04, to lugnet.cad.dat.parts.primitives)
|
|
| | Re: I want to become a reviewer
|
|
(...) Yes - these kind of errors are not a cause for a hold. I'm with Orion on stud rotation, but I'd prefer not to have parts/subparts designed in a way that causes mirrored studs. We have set a precedent with car doors, by moving the stud from the (...) (20 years ago, 4-Nov-04, to lugnet.cad, FTX)
|
|
| | Re: half size 3004
|
|
(...) Ok, Thank you :) I'd be happy to beta test 3.0 when you make it available. Thanks again. (20 years ago, 4-Nov-04, to lugnet.cad)
|
|
| | Re: cylinders missing conditional lines?
|
|
(...) This thread pops up from time to time and never seems to get resolved. (URL) think the problem is this: If you fix the all the primitives, then you really must check all the parts that use them. So we end up ignoring it and moving on. If (...) (20 years ago, 4-Nov-04, to lugnet.cad.dat.parts.primitives)
|