| |
In lugnet.build, Lindsay Frederick Braun writes:
> The obvious solution for me is a frame-by-frame construction, with
> each stud being rendered into a "frame." So I'll be building the
> flare out SNOTwise below deck level. I have frame-by-frame diagrams
> of _Takao_ which shall be adequate. It's not going to be perfect,
> and there will be pixellation, but I expect it won't be a jump of more
> than 2.5 plates' height anywhere.
Interesting. I've been trying to figure out a stable solution for strange
curves like that for my next wet-navy project... this might be what I'm
looking for. Hmm...
> The stern, thankfully, is virtually straight vertically.
Small favors, eh? : )
Kenneth Tam
|
|
Message has 1 Reply:
 | | Re: Railing prototype for heavy cruiser
|
| (...) What I do is build the general curve around the blocky basis of the hull--you know, a vertically straight horizontal curve. Then I build the curve outward on that. It does mean that my internal order is square; but it also means that I can use (...) (23 years ago, 17-May-02, to lugnet.build, lugnet.build.military)
|
Message is in Reply To:
13 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
