Subject:
|
Re: Chain link fence/fence ideas.
|
Newsgroups:
|
lugnet.build
|
Date:
|
Fri, 20 May 2005 20:16:54 GMT
|
Viewed:
|
2198 times
|
| |
|
|
| |
How about using 1x4x2 fences, somehow put together snot-wise:
|
That is how I do it. But, I don’t make them that high.
| |
I actually don’t think my snot solution works there. I find it hard to tell
from ldraw, but it seems like the studs on the 1x1 bricks with studs on all
sides (and, btw, the 1x1 bricks with studs on two sides would be better; I
just have an older version of mlcad) don’t exactly match up. If I had my
bricks I could play around with the idea a little more, but perhaps that sort
of idea would work?
|
Remove the 1x1x5 column and use a combination of 1x1x1 bricks and 1x1 plates &
it would work.
Jonathan
|
|
Message is in Reply To:
 | | Re: Chain link fence/fence ideas.
|
| (...) I feel certain that I've seen someone use the 8x8 plates with grills: (URL) I thought it might be in Keith Goldman's Iron Reich models, but don't see anything. Wait a minute ... ... opens ldraw ... ... 20 minutes later ... How about using (...) (20 years ago, 20-May-05, to lugnet.build, FTX)
|
15 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
