 | | Re: Building pyramids. (Was: Announcing my newly completed website)
|
|
(URL) on there somewhere is a link to Paulo's dat2dxf converter. There is also a zip file containing a few sample conversions. I have yet to use the actual program....as the bricks I needed were there in the zip file....though I will be shortly. And (...) (26 years ago, 28-Oct-98, to lugnet.build)
|
| |
| | Re: Building pyramids. (Was: Announcing my newly completed website)
|
|
(...) where can I get the above mentioned DXF converter? -- ___...___ L. M. Lloyd lee@advfilms.com SGI Animator ADV Films USA ___...___ (26 years ago, 27-Oct-98, to lugnet.build)
|
| |
| | Re: Building pyramids. (Was: Announcing my newly completed website)
|
|
(...) Oba! I am glad someone is using it! (...) Paulo (26 years ago, 27-Oct-98, to lugnet.build)
|
| |
| | Re: Building pyramids. (Was: Announcing my newly completed website)
|
|
Certainly. They both demonstrate studs, as opposed to actual bricks. I was very tired when I wrote it..... The picture I had hoped to demonstrate how bricks on different levels should relate to each other. I think what would be best might be a (...) (26 years ago, 27-Oct-98, to lugnet.build)
|
| |
| | Building pyramids. (Was: Announcing my newly completed website)
|
|
Richard, I wonder if you could clear this up a little bit? (...) I understand how this makes a pyramid. (...) I don't understand how this makes a pyramid. Does the pyramid rise with a less steep angle now? Are these three lines one vertical section? (...) (26 years ago, 27-Oct-98, to lugnet.build)
|
| |
| | Re: Announcing my newly completed website
|
|
Actually, I had decided to go very big on a pyramid, which I finished last weekend. After building a pyramid on a 48x48 baseplate (nice sounding drum, by the way), went for an 80-stud wide pyramid, built upon a 48x48 surrounded by a ring of 16x32's. (...) (26 years ago, 26-Oct-98, to lugnet.build)
|
| |
| | Re: Identify this pneumatic piece
|
|
Matthew Bates wrote in message ... (...) Which leads me to think that the pneumatic switch is different now (...) Actually, no. The crucial difference between the old and the new pneumatics system is that the old one used both pressure and suction, (...) (26 years ago, 26-Oct-98, to lugnet.build)
|
| |
| | Re: Identify this pneumatic piece
|
|
(...) That's the piece! Except mine's black. Matt (26 years ago, 26-Oct-98, to lugnet.build)
|
| |
| | Re: Rocker-boogie suspension model
|
|
Hey, that is one cool model. It took me a while to figure out how to build from the instructions included, but it is worth it! If there is interest, I could take pictures of the rocker-boogie with my digital camera and post pictures on my web page. (...) (26 years ago, 23-Oct-98, to lugnet.build, lugnet.robotics)
|
| |
| | Re: Announcing my newly completed website
|
|
Louise Belles wrote in message ... (...) remove (...) which (...) that (...) spots. (...) that (...) been (...) great (...) a (...) I hear you, one of my ex's, Donna (sister of RTLer Denny who doesn't post much these days) is a Structural engineer (...) (26 years ago, 23-Oct-98, to lugnet.build, lugnet.general)
|
