|
|
 | | Re: Digit outputs....
|
| Rather than trying to figure out the hex for the bits, I use the IC binaray number format, "0b". I set the bits using a binary mask, for example, to set the MOSI pin high, I use: bit_set(0x1008, 0b00001000) then to set the MOSI pin low, I use: (...) (28 years ago, 20-Feb-97, to lugnet.robotics.handyboard)
| | | | | Digit outputs....
|
| I've tried to program the digital outputs from the SPI header J6 on the HB with no success. I pump the values into the HB as per instruction form the FAQ note and measure the 4 outputs. No high/low, just some sort of oscillation. What could be my (...) (28 years ago, 20-Feb-97, to lugnet.robotics.handyboard)
| | | | | Re: Motors & handyboard
|
| (...) This is also excellent advice. On one R/C car I had, I ended up having to simulate the signal input to the controller because the h-bridge was so screwy but it does save you from having to build your own. On a related note, Radio Shack sells (...) (28 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
| | | | | Re: Motors & handyboard
|
| (...) Why not use the H-bridge that is already on the bulldozer? If you work backwards throught the motor driver circuitry, or use the RF controller to send commands to the dozer and see what voltages change you can figure out where the inputs to (...) (28 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
| | | | | Re: running .s19
|
| shouldn't you be going into expanded mode, not single chip? (...) (28 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
|
|
