Subject:
|
Re: running .s19
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 19 Feb 1997 18:50:58 GMT
|
Original-From:
|
Matt Harlan <mjh10@SPAMLESScornell.edu>
|
Viewed:
|
1305 times
|
| |
|
|
shouldn't you be going into expanded mode, not single chip?
At 1:17 AM -0600 2/19/97, Luke wrote:
> Hello,
>
> I am trying to use normal .asm files assembled with as11 on the
> handy-board. I am not using IC. Although my .s19 file downloads fine I
> don't think it is being run. My code begins at $D000. I use an ORG
> statement to set $BFFE:$BFFE to $D000. By turning the board off and on I
> think it should cause a RESET which in the special test mode will fetch
> the vector $BFFE:$BFFF. The fist thing my program does is clear the MDA
> bit, then clear the SMOD bit to get back into normal single chip mode.
> What am I missing?
>
> -Luke
|
|
Message is in Reply To:
 | | running .s19
|
| Hello, I am trying to use normal .asm files assembled with as11 on the handy-board. I am not using IC. Although my .s19 file downloads fine I don't think it is being run. My code begins at $D000. I use an ORG statement to set $BFFE:$BFFE to $D000. (...) (27 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
