Subject:
|
Re: Western Train with instructions
|
Newsgroups:
|
lugnet.trains, lugnet.cad
|
Date:
|
Tue, 16 Dec 2008 21:02:44 GMT
|
Viewed:
|
20348 times
|
| |
|
|
In lugnet.trains, Michael Heidemann wrote:
| |
In lugnet.trains, Philippe Hurbain wrote:
| |
| |
Notice that there are some fairly dark colors that still have black edges,
and to my eye, they’re just light enough for the black edges to still have
enough contrast. The dark brown at the far end had black edges with a
threshold of 3500, and that was not quite enough contrast. With 3600 the
above looks good to me. The real question is, should I change “Always
black” in LDView to do this. Thoughts?
|
I always considered that “Always black” was unusable since dark colors were
illegible. So for me the answer is yes. I would be tempted to push the
threshold further: even if there is enough contrast on screen, it could be
insufficient in print.
Philo
|
I agree fully with Philo’s thoughts about the “Always black” edgelines.
cu
mikeheide
|
So do I but going back to the original issue which instructions are using the
black edgelines?
Tim
|
|
Message has 1 Reply:
 | | Re: Western Train with instructions
|
| (...) Ahhh I found them. The original loco and the last two. I must have accidentally switched LPub across to a different setting before doing (and redoing in the case of the loco) the instructions. Newer versions will be uploaded. Tim (16 years ago, 16-Dec-08, to lugnet.trains, lugnet.cad, FTX)
|
Message is in Reply To:
15 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
