Subject:
|
Re: Super Chief set not ready for prime-time
|
Newsgroups:
|
lugnet.trains, lugnet.lego.direct
|
Date:
|
Sun, 12 Mar 2006 16:12:29 GMT
|
Viewed:
|
12417 times
|
| |
|
|
In lugnet.trains, Larry Pieniazek wrote:
> In lugnet.trains, Peter Edwards wrote:
> > In lugnet.trains, Peter Edwards wrote:
> > > The extra circumference of the brass keeps the axle from seating too low, so it
> > > will not rub on the frame.
> >
> > http://www.brickshelf.com/gallery/pe668/Crazy/z-100_1440.jpg
>
> Brilliant. How much would those cost to have run off in large quantities I
> wonder? Way better solution than knifing away plastic if it works...
>
> ++Lar
Hi all!
This is in fact a nice idea!
But I have one comment to make: this solution is causing friction between brass
tube and metal axle, while the original solution is "rubbing" only on the very
tip of the metal axle. The higher the diameter of the friction zone, the higher
the torque to overcome.
For light weight waggons this solution will end up in a (somewhat) higher
running resistance (maybe not to mention if you put a miligramm of grease in
between).
For heavier waggons this would be a perfect and reliable solution! Excellent
idea and thanks for sharing it!
Leg Godt!
Ben
|
|
Message has 1 Reply:
Message is in Reply To:
50 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
