To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 18053
18052  |  18054
Subject: 
Re: Super Chief set not ready for prime-time
Newsgroups: 
lugnet.trains, lugnet.lego.direct
Date: 
Wed, 16 Oct 2002 21:28:30 GMT
Viewed: 
4632 times
  
I ment that I called up LEGO and they sent me a whole new set of wheels.
THey had no problem with it. After replacing the old SF wheels with the new,
I looked at what would cause the high friction. It looks like the outer most
diamater of the wheel was rubbing on the frame.
Hope that clears that up.

Dave




In lugnet.trains, Stefan Garcia writes:
When you say you replaced the wheels, are you referring to the whole kit 'n
caboodle or just the axle?

-Stefan-

In lugnet.trains, David VinZant writes:
I have two Santa Fe engines and a B Unit I built to go with them. I have two
moters one on each of the A units. I too had a hard time with the SF engines
pulling more then 10 cars. It always seemed to bog down in the turns.
Recently I had all my Gray wheels replaced and now my SF runs 10 times
better. Infact with it set only at power setting 1 it will pull ten cars
with no problem through the turns. I dont have any of the SF coaches so I
cant do a test with them. But getting the wheels replaced seems the best
option if you have problems with the SF running sluggish.


Dave



In lugnet.trains, Jean-Marc Détraz writes:
I'm finding little reason to the whole friction issue.

My CN engine has two motors on it and it runs very fast on power level 2 of
the controller. I can tow 10 cars behind it without an issue

Now my legend Metroliner has issues on curves, it slows right down and makes
such an noise.

I agree with that! And I bought all of the newer cars (10013/14/15/16/17)
and buy just making a very simple train with them + 1 loc, it has a very
hard time on curves and not fast on a straight track. I never had that
problem with all the trains I had before, especially the noise...
Saddly to wonder what's going on and should I buy more train cars in the
future? I'm planning on buying (investing!) on the new 10022/25 but now I'm
not so sure.

Can someone have a good review to make?

Jean-Marc




Message has 2 Replies:
  Re: Super Chief set not ready for prime-time
 
Yup. Thanks. -Stefan- (...) (22 years ago, 17-Oct-02, to lugnet.trains, lugnet.lego.direct)
  Re: Super Chief set not ready for prime-time
 
(...) That's it in a nutshell. I bought some SF carriages and Super Chief and after running them for only a short amount of time it slowed right down. The Motor was cutting out due to the load, from the weight of these heavier carriages. Not the (...) (19 years ago, 10-Mar-06, to lugnet.trains, lugnet.lego.direct)  

Message is in Reply To:
  Re: Super Chief set not ready for prime-time
 
When you say you replaced the wheels, are you referring to the whole kit 'n caboodle or just the axle? -Stefan- (...) (22 years ago, 16-Oct-02, to lugnet.trains, lugnet.lego.direct)

50 Messages in This Thread:



















Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR