To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 26971
26970  |  26972
Subject: 
Re: Super Chief set not ready for prime-time
Newsgroups: 
lugnet.trains, lugnet.lego.direct
Date: 
Sat, 11 Mar 2006 23:32:01 GMT
Viewed: 
12039 times
  
In lugnet.trains, Peter Edwards wrote:
The extra circumference of the brass keeps the axle from seating too low, so it
will not rub on the frame.

http://www.brickshelf.com/gallery/pe668/Crazy/z-100_1440.jpg



Message has 2 Replies:
  Re: Super Chief set not ready for prime-time
 
(...) wonder? Way better solution than knifing away plastic if it works... ++Lar (19 years ago, 12-Mar-06, to lugnet.trains, lugnet.lego.direct)  
  Re: Super Chief set not ready for prime-time
 
(...) (URL) Brick Blast Vermont>. This was are first experiance doing a mid summer train show and it was extremely hot and humid durring the event. My trains which have been running at shows for 7+ years would not run at all because of the friction (...) (18 years ago, 3-Aug-06, to lugnet.trains, lugnet.lego.direct, FTX)

Message is in Reply To:
  Re: Super Chief set not ready for prime-time
 
(...) That's it in a nutshell. I bought some SF carriages and Super Chief and after running them for only a short amount of time it slowed right down. The Motor was cutting out due to the load, from the weight of these heavier carriages. Not the (...) (19 years ago, 10-Mar-06, to lugnet.trains, lugnet.lego.direct)  

50 Messages in This Thread:



















Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR