To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 26448
26447  |  26449
Subject: 
Re: Some more infos on new trains (they were partly presented in Frechen/Germany)
Newsgroups: 
lugnet.trains
Date: 
Sun, 8 Jan 2006 15:52:53 GMT
Viewed: 
3229 times
  
In lugnet.trains, Reinhard "Ben" Beneke wrote:
Hi all!

Jan Beyer has shown us parts of the new train System in Frechen/Germany.

Just some unassortet aspects and informations.

- The track is full plastic as already seen.
- The train base is 32 studs long and contrains IR recievers on both sides and
battery box (included and not removable).
- the train motor has plastic wheels.
- the wheels show spokes on their faxe sides and have technik axle holes.
- the motor has special technic axle holes (nearly with cylindrical bore: so
they have a "slip-under-overload-effect")
- no new track radius is planned (so far) as Jan mentioned
- the engine needs 6 pieces of small standard batteries => still a 9V system
- the control panel (made for lefthanded kids as it seemed to us) has only 4
knobs and a frequency switch.
knob 1: signal horn (in panel)
knob 2: stop
knob 3: pos. accelleration  (speed up or break rearwars drive)
knob 4: negative. accelleration (break or speed up backwarts)

The frequency switch allows to choose betweeen 3 frequencies or controls all 3
frequencies at one time. I ask myself, what would happen if any of my three
nephews wanted to own a second train....

Kind Regards,

Ben

P.s.: the new mindstorms system got presented as well (even photos were allowd).
The mindstorms fans where really exited and positive against the system. I have
no idea about the old mindstorms so I cannot tell anything about improovements
now....



thank you for the info ben!

i have a couple quick questions i hope you don't mind.

is there any info on a release date?
the wire that goes to the motor, is that the same old 2x2 conecter?
i assume the battery box is on the bottom side of the train base, is this a
correct assumption?
is the base screwed together or glued?

pictures?????

thanks,
ondrew



Message has 1 Reply:
  Re: Some more infos on new trains (they were partly presented in Frechen/Germany)
 
(...) [SNIP] (...) Hi Ondrew, picture taking was not allowed and we have respected this limitation. Release date will be in september (as planned so far) I had less than 3 minutes to have a view on the system. I have not demounted the motor from the (...) (19 years ago, 8-Jan-06, to lugnet.trains)

Message is in Reply To:
  Some more infos on new trains (they were partly presented in Frechen/Germany)
 
Hi all! Jan Beyer has shown us parts of the new train System in Frechen/Germany. Just some unassortet aspects and informations. - The track is full plastic as already seen. - The train base is 32 studs long and contrains IR recievers on both sides (...) (19 years ago, 8-Jan-06, to lugnet.trains)  

45 Messages in This Thread:


















Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR