Subject:
|
Re: Draft of a new driver wheel
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Wed, 5 Nov 2003 19:47:11 GMT
|
Viewed:
|
2531 times
|
| |
|
|
In lugnet.trains, John Gerlach wrote:
| |
In lugnet.trains, Reinhard “Ben” Beneke wrote:
| |
Hi all!
In the past we have collected some demands we train heads have on driver
wheels. These have been requested several times at TLC so far.
Here comes the wishlist to make up a draft for a new driver wheel:
|
snip
One question, I can’t really tell from the images:
Is the distance between the axle hole and the peg hole a standard stud
distance?
|
Good question! It “arguably” doesn’t matter as much as some distances though,
unless you plan to mount something between them. In many applications you just
have the main rod and or connecting rod to deal with and the eccentricity they
have is only a factor in considering how much connecting rod and piston rod
throw you’re going to have to deal with.
Still it would be nice to know. Personally I hope it’s rather short.
|
|
Message has 1 Reply:
 | | Re: Draft of a new driver wheel
|
| (...) Well, I know how pointless it would be to "argue" with Lar (grin), but it would seem silly to not have this be a standard distance. I could easily imagine using a Technic cam or 1x3 liftarm on a wheel. (John frantically searching for FTX (...) (21 years ago, 5-Nov-03, to lugnet.trains, FTX)
|
Message is in Reply To:
| | Re: Draft of a new driver wheel
|
| (...) snip One question, I can't really tell from the images: Is the distance between the axle hole and the peg hole a standard stud distance? JohnG, GMLTC (21 years ago, 5-Nov-03, to lugnet.trains, FTX)
|
56 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
