To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 21381
21380  |  21382
Subject: 
Re: Draft of a new driver wheel
Newsgroups: 
lugnet.trains
Date: 
Tue, 28 Oct 2003 20:36:44 GMT
Viewed: 
2124 times
  
I have it on good information that a third party supplier will soon be sending out a set of custom drive wheels meeting many of these criteria to a select group of AFOL train builders for evaluation.

Cheers

Ben Fleskes



In lugnet.trains, Reinhard “Ben” Beneke wrote:
   Hi all!

In the past we have collected some demands we train heads have on driver wheels. These have been requested several times at TLC so far.

Here comes the wishlist to make up a draft for a new driver wheel:

1.) technic axle center

2.) peg hole for connecting rods

3.) diameter bigger than set 7750 and smaller than set 396

4.) flange design similar to 9V wheels

5.) narrow gaps between two wheels

6.) distance between centers of two neighbour wheels in a “common” dimension (4 stud / 5 stud / 6 stud?)

7.) running diameter dimension fitting to 9V and 12V wheel diameters

8.) wheel thickness higher than 9V and less than 1 stud (avoid contact between moving rods and wheel)

9.) counterweight as “click-on” extra part, (if 2 moulds were possible)

10.) shape not 100% after real prototypes but kind of “legoish”.

11.) center stud with Legologo

12.) ((Extra wish -Additionally a wheel without flange (blind driver) should be available.))

snip



Message has 1 Reply:
  Re: Draft of a new driver wheel
 
(...) Hmmm, Any chance that one could coerce you to mention to your good informer that someone (ahem) would love to find his name (ahem) among said group? Seriously ... I'd love to have the opportunity to play with a couple of these. Drive wheels (...) (21 years ago, 28-Oct-03, to lugnet.trains, FTX)

Message is in Reply To:
  Draft of a new driver wheel
 
Hi all! In the past we have collected some demands we train heads have on driver wheels. These have been requested several times at TLC so far. Here comes the wishlist to make up a draft for a new driver wheel: 1.) technic axle center 2.) peg hole (...) (21 years ago, 28-Oct-03, to lugnet.trains, FTX) !! 

56 Messages in This Thread:

























Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR