Subject:
|
Re: Draft of a new driver wheel
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 4 Nov 2003 10:30:39 GMT
|
Viewed:
|
2366 times
|
| |
|
|
In lugnet.trains, Larry Pieniazek wrote:
| |
In lugnet.trains, Reinhard “Ben” Beneke wrote:
| |
In lugnet.trains, Tim David wrote:
| |
In lugnet.trains, Reinhard “Ben” Beneke wrote:
|
|
| |
| |
| |
11.) center stud with Legologo
|
not at all essential (imho)
|
But it would be really nice in case the wheel is from a third party: it
gives a more legoish feeling and increases the acceptance(imho).
|
A third party wheel CLEARLY could NOT have the LEGO logo on it... so your
solution of sizing an opening to let the user insert a 1x1 round plate (and
thus having the logo on there if they wish) is absolutely brilliant. It ALSO
leaves the door open to someone building an outside frame locomotive since
the axle hole allows the axle to pass all the way through.
|
I’d missed the fact that the ‘cover’ could be a 1X1 round, that is a veryy good
idea. One of my misgivings with a cover was the fact of outside framed locos so
this would be best all round
Tim
|
|
Message is in Reply To:
 | | Re: Draft of a new driver wheel
|
| (...) A third party wheel CLEARLY could NOT have the LEGO logo on it... so your solution of sizing an opening to let the user insert a 1x1 round plate (and thus having the logo on there if they wish) is absolutely brilliant. It ALSO leaves the door (...) (21 years ago, 3-Nov-03, to lugnet.trains, FTX)
|
56 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
