| |
In lugnet.trains, Shaun Sullivan writes:
> http://www.nelug.org/greenberg0402/P4070044.JPG
> It was a big hit ... there were many cries of "Look at the last car when that
> train comes around again!" and the like.
I can see why... :-)
Shaun, this is one of the neatest ideas I've ever seen portrayed in LEGO.
Well done!
> Currently, the tension in the chains is a bit high, such that the motor starts
> to get hot and jumpy after about 20 minutes of continuous operation. I'm
> figuring to either gear the whole thing down a bit, or add a spring-loaded
> tensioner rather than use the standard technic hole spacing to relieve that
> problem.
You got me curios, now: what kind of spring-loaded tensioner would you use,
and how would you place it?
Pedro
|
|
Message has 1 Reply:
 | | Re: Train-on-a-train Car
|
| (...) Thanks! (...) Right now, the vertical axles that the gears are on are located in the technic holes in a standard train baseplate. For some reason, this seems to add a great deal of tension to the axles. In fact, I noticed (prior to putting a (...) (22 years ago, 9-Apr-02, to lugnet.trains, lugnet.loc.pt)
|
Message is in Reply To:
| | Train-on-a-train Car
|
| After seeing Larry's LDRAW rendition of the 2-wide train designed by Jorn ((URL) I decided to try and incorporate it into a "full-scale" train car. The result was an 8-wide flatbed with a small train running atop it: (URL) also a 3.5 MB mpeg of it (...) (22 years ago, 9-Apr-02, to lugnet.trains) !
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
